Magnum 4K8 Switches Installation and User Guide (10/04)

new frequently-used addresses. To reset the address buffer, cycle power down-and-up.

4.2Status LEDs

For Magnum 4K8 models :

PWR

: Power LED, ON when external power is applied to the unit.

ERROR

: Self-test at power up failed

LK/Act

: Steady ON for link with no traffic, blinking indicates port is

 

transmitting and receiving.

F/H

: Full / Half duplex LED, ON when the port is running full

 

duplex, OFF for half duplex.

Speed

: Speed LED, ON when the speed is 100Mbps , OFF when the

 

speed is 10 Mbps

4.3Manual Switches for Up-link push-button, for RJ-45 Port#1 only

Figure 4.3 : Up-link push-button on RJ-45 Port#1

POWER

SPEED 1

2

3

4

5

6

7

8

ERROR

L/A

 

 

 

 

 

 

 

UPLINK

F/H

 

 

 

 

 

 

 

FF =

X A

The Magnum 4K8 Switch has a manual Up-link sliding switch, located on the front panel next to 10/100Mb RJ-45 port # 1 which it controls. It enables the port’s cable to either connect to a user station node (push in) or to be cascaded (push out) to a 10/100Mb repeater or switching hub in the network. Verify proper Up-link push-button position by noting Port 1’s LK (link) LED status, which is illuminated when a proper link is made.

4.4Manual Switches “F-H”, for FPM Port#9 only

The Magnum 4K8 Switch has a manual sliding switch called “F-H” located on the front panel next to Fiber port # 9 which it controls. While on “F” position enables the port # 9(Fiber port module) to full fixed 100Mbps only whereas in “H” position led the port#9 to set at half-duplex.

The Magnum 4K-Series Fast Ethernet bonus copper port# 9 can be set for either fixed 100Mb speed or for 10/100 F/H N-way auto-negotiation per the IEEE802.3u standard. The selection is made via an internal jumper. The factory default setting for RJ-45 port is auto-negotiation

4.5Auto-negotiation, for Fast Ethernet copper ports

One frequently-used application for the Magnum 4K8-Switch copper ports is to connect one of them using a fiber media converter to another Switch in the network

www . GarrettCom . com

24

Page 30
Image 30
GarrettCom 4K-Series manual Status LEDs, Manual Switches F-H, for FPM Port#9 only, Pwr, Error