Magnum 500-Series Switching Hubs | Installation and User Guide (08/98) |
| |
3.1.2Wall (or Vertical Surface) Mounting
Each Magnum 500-Series switch is shipped with two metal mounting brackets (and screws) to allow the unit to be mounted in nearly any desired orientation or position. The brackets are attached to the metal hub case using one of the metal screws for each bracket, and attached to the Magnum 500 through the round hole of the bracket. A user- supplied screw attaches the bracket to the mounting surface. It is recommended that the mounting brackets be attached to two opposite corners of the unit. When properly attached, the brackets will extend slightly below the base of the unit to allow clearance for the rubber feet and for cooling fan exhaust space.
Magnum 500-series
Switching Hub
GARRETT
Proper mounting
Magnum 500 with attachedbracket attachment mounting brackets
Figure 3.1: Magnum 500-Series, metal mounting brackets
3.1.3Optional E-Stand
The optional E-Stand provides a vertical mounting option for the Magnum 500-Series Hubs. When horizontal placement is not possible or desirable (such as on the floor in carpeted areas), the E-Stand offers a unique space management option. Simply align the rectangular cut-out on the E-Stand with the air vent on either side of the Magnum 500 unit.
The E-Stand also allows the Magnum 500-Series unit to be securely mounted via two screws that connect through the E-Stand and into the side of the unit.
See Figure 3.1.3, following.
GARRETT 
