GarrettCom 6K25e manual 10/100

Magnum 6K25e Gigabit Fiber Switch Installation and User Guide (10/07)

When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data traffic is not affected by PoE.

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED that is marked as LINK/ACT, as shown in the diagram.

PoE LEDs Summary

•For PoE devices, each RJ-45 PoE port supports only 802.3af complaint devices. The PoE LED is ON when the attached PD is drawing power from the port.

•For non-PoE devices connected, the PoE port will act as a normal RJ-45 port and the PoE LED is OFF. No power is being sent out from the port.

•The PoE ports in Magnum 6K’s with 48VDC power input act as a pass- through, so the 48VDC power source must be strong enough to provide power to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to 15 watts per PoE port).

•In the case where the 48VDC power in not internally connected and no power is coming to the PoE ports for some reason, all the PoE port LEDs are ON simultaneously to indicate a trouble condition. The ports will still operate properly for data traffic.

5.2.126KP8-45-2MT, 6@ 10/100Mbps RJ-45 and 2@100Mb multi-mode FX , MTRJ Small-Form-Factor

The Magnum 6KP8- 45-2MT eight port Module is a combo module with copper and fiber (Small Form Factor)

MTRJ type ports. The small sizes of MTRJ connectors give an advantage of placing more fiber ports on one module. The 6KP8-45-2MT is equipped with six 10/100 RJ-45 ports and two 100Mb MTRJ fiber ports. When standard distances as mentioned

6KP86KP8V-45-2MT-
6 Port@10/10Mbps		& 2 port @100Mb
Multi-Mode Fiber port
	2
1	3	5	1
10/10		L

4					AC
F/H
10/100					ACT
					F/H
					ACT
F/H	2	4	LK	6	F/H	3

1 LINK 2 10/100

3 ACTIVITY 4 FULL/HALF

installed in a Magnum 6K25e Switch, it supports the on 5.2.3. and the LEDs also act similarly.

5.2.12a 6KP8-45-2LC, 6@ 10/100Mbps RJ-45 and 2@100Mb single-mode FX , LC Small-Form-Factor

www . GarrettCom . com

53