Using the Gateway 205 Projector
11
12
Turn the projector over.
Connect the power cable and all external cables.
To reset the lamp timer:
1 Press the POWER button on the top of the projector twice, a warning message appears.
2 Press the AUTO and BLANK buttons at the same time. A lamp hour icon will appear on the screen.
3 Press the AUTO button to reset the lamp timer.
Cleaning the projector
Keeping the projector clean and the vents free from dust helps keep it performing at its best.
Warning
Make sure that the projector is off, power is disconnected, and the lamp is completely cool (minimum of 45 minutes) before cleaning the projector.
Cleaning the exterior
Always turn off the projector and wait for it to cool before cleaning it.
Use a damp,
The projector is cooled by air circulated through the vents on the case, so keep the vents free of dust. With the projector turned off and unplugged, brush the dust away from the vents with a damp cloth. Be careful not to drip any water into the vents. Do not attempt to clean dust from the inside the projector.
Cleaning the projector lens
Always turn off the projector and wait for it to cool before cleaning the projector lens.
Use a soft cloth and glass cleaner to clean the projector lens. Squirt a little cleaner on the cloth (never directly on the lens), and wipe the lens with the cloth.
30 | www.gateway.com |
