CHAPTER 7: Troubleshooting

Modem (dial-up)

See also “Internet and networking” on page 102.

Your modem does not dial or does not connect

•Make sure that the modem cable is plugged into the modem jack and not the Ethernet or the PHONE network jack.

•Make sure that your computer is connected to the telephone line and the telephone line has a dial tone.

•Remove any line splitters or surge protectors from your telephone line, then check for a dial tone by plugging a working telephone into the telephone wall jack.

•Make sure that call waiting is disabled before using the modem. Contact your telephone service provider to get the correct code to temporarily disable the service.

•Make sure that the modem dialing properties are set correctly.

To check the dialing properties:

1Click (Start), type modem, then press ENTER.

2If the Location Information dialog box opens, enter the information for your area, then click OK.

3Click the Dialing Rules tab, click the location from which you are dialing, then click Edit.

4Make sure that all settings are correct.

Help

For more information about dialing properties, click Start, then click Help and Support. Type dialing in the Search Help box, then press ENTER.

•Check for line noise (scratchy, crackling, or popping sounds), which is a common problem that can cause the modem to connect at a slower rate, interrupt downloads, or even disconnect. You can also call your telephone service and have the telephone line checked for noise or low line levels.

•Try another telephone line (either a different telephone number in your house or a telephone line at a different location). If you can connect on this line, call your telephone service.

104