www.gateway.com
7If you are replacing a drive, note any jumper settings on the old drive and set the jumpers on the new drive to be the same. If you are installing a new drive, follow the manufacturer’s instructions.
8Slide the new drive into the drive bay, line up the thumbscrew hole on the drive bay with the screw hole on the drive, then slide the drive release latch toward the front of the computer to lock the drive into place. You do not need to replace the thumbscrew because it was originally installed for shipping purposes.
9Connect the drive cables using your notes from Step 3. If you are installing a new drive, follow the manufacturer’s instructions.
10Replace the front bezel by following the instructions in “Replacing the front bezel” on page 50.
11Replace the side panel by following the instructions in “Replacing the side panel” on page 50.
Replacing the memory card reader
To replace the memory card reader:
1Remove the side panel by following the instructions in “Removing the side panel” on page 47.
2Remove the front bezel by following the instructions in “Removing the front bezel” on page 49.
3Disconnect the memory card reader cables, noting their locations and orientation. (You will reconnect the cables after you install the new memory card reader.)
55