www.gateway.com

Preparing your computer for RAID

Setting up RAID on your computer can involve two major steps, depending on how your computer has been configured.

To prepare your computer for RAID:

1Configure the RAID arrays. See the Array Manager User Guide, or “Configuring RAID” on page 33.

2Install the operating system.

Configuring RAID

Enabling RAID

If your computer had RAID enabled at the factory, you do not need to enable it. If you are setting up RAID yourself, and RAID was not enabled at the factory, you must enable it.

To enable RAID on your computer:

1Start (or restart) your computer.

2As soon as your computer turns on and the Gateway logo appears on the screen, press F2. The BIOS Setup utility opens.

3Select the Advanced menu, then select Drive Configuration.

4Change the ATA/IDE Mode to Enhanced.

5Change the SATA mode to RAID.

6Press F10, then type Y to exit BIOS saving changes.

Now that RAID is enabled, you can access the RAID setup.

33