CHAPTER 4: Upgrading Your Computer

5Slide the drive release latch toward the back of the computer to release the drive.

6Slide the drive forward and out of the drive bay.

7If you are replacing a drive, note any jumper settings on the old drive and set the jumpers on the new drive to be the same. If you are installing a new drive, follow the manufacturer’s instructions.

8Slide the new drive into the drive bay, line up the thumbscrew hole on the drive bay with the screw hole on the drive, then slide the drive release latch toward the front of the computer to lock the drive into place. You do not need to replace the thumbscrew because it was originally installed for shipping purposes.

9Connect the drive cables using your notes from Step 3. If you are installing a new drive, follow the manufacturer’s instructions.

10Replace the front bezel by following the instructions in “Replacing the front bezel” on page 44.

11Replace the side panel by following the instructions in “Replacing the side panel” on page 44.

Adding or replacing an optional diskette drive

To add or replace a diskette drive:

1Remove the side panel by following the instructions in “Removing the side panel” on page 41.

2Remove the front bezel by following the instructions in “Removing the front bezel” on page 43.

50