CHAPTER 3: Replacing notebook components
64
Replacing the LCD panel assembly
Tools you need to complete this task:
Screws removed during this task:
•3 black M2.5×6 (keyboard cover)
• 2 black M2.5×6 (LCD panel hinges - bottom)
• 2 black M2.5×6+Nylok (LCD panel hinges - top)
To replace the LCD panel assembly:
1Complete the steps in “Preparing the notebook” on page47.
2If the notebook has a wireless card installed, complete the steps in
“Removing the bay cover” on page49, and then unplug the antenna cables.
If there’s no wireless card installed, proceed to step5.
3Remove the keyboard by performing steps 2–4 of the “Replacing the
keyboard” procedure on page 62.
4Turn the notebook over so the base is facing up.
5Remove the base screws that secure the LCD panel hinges.
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
Phillips #0 screwdriver
Flat screwdriver or Non-marring plastic scribe