6

Chapter 1: Checking Out Your Gateway M1300 Tablet PC

www.gateway.com
Power switch side

Component Description

Power connector Plug the ACadapter cable into this connector. Do not substitute
another adapter or use this connector for any other purpose.
Power switch Turn on the tablet by sliding and holding the switch for about
1 second.
When the Gateway TabletPC is on, slide the switch briefly to
activate Standby (or Hibernate if it is enabled through the Control
Panel’s Power Options Properties dialog box).
Sliding and holding the switch for more than 4 seconds (when th e
tablet is turned on) will cause a forced shutdown, which is the last
resort when the tablet is completely unresponsive.
Antenna zone The wireless networking antennas are located in this area. Make
sure that you keep your hands clear of this zone when using
wireless connectivity in areas where reception is weak.
PC Card slot Insert one TypeII PC Card into this slot. For more information, see
“Adding and removing a PCCard” on page 218. A plastic blank
ships with the Gateway TabletPC, and you can leave it in place
whenever the slot is not in use.
Pen tether
anchor Use this tether anchor to tether the pen to the tablet. You must
purchase the pen tether separately.
Power
connector Power switch
Antenna area Pen tether
anchor
PC Card slot