GateWay Fax Systems 90SI 6 1-Line Dual-Mode with 910 Option, Setting Your Chosen Configuration

GateWay Fax Systems, inc. Model 90si Secure Fax Gateway User's Guide

2.3.61-Line Dual-Mode with 910 Option

This configuration requires the optional Model 910 Auto Fax/STE Switch which allows your fax to function as both your Primary non-secure as well as your Primary secure fax while using only one telephone line. No operator need be present to receive a non-secure fax.

Set the Configuration to (03) 2-Line Dual-Mode. See Section 2.4, Setting Your Chosen Configuration for in- structions on how to do this.

90si Secure Fax Gateway

Rear Panel

	Commercial-Off-The-Shelf
LINE	Fax	Machine
	(Set to Auto-Answer on 1 Ring)

FAX

				TEL LINE				Phone
							Model 910
5VDC Power							Automatic	Line
	Supply		"Red"				Fax/STE
									Telephone
					PSTN		Switch
			Data Port						Wall Jack
			Secure Telephone
			/ Crypto
			(Set to Async 9.6kbps)
						910 Option Configuration
		Figure 4: 1-Line, Dual-Mode with

2.4Setting Your Chosen Configuration

If you are using the Secure Only Configuration and your 90si is new from the factory, you need not set the config- uration. If on the other hand your 90si is not factory new or you have chosen one of the Dual-Mode configurations you will need to tell the 90si what configuration you will be using. This is done using DTMF tones from the FAX dial pad while in the Default Settings mode. The confiuration options and code numbers are shown below:

90si Default Settings List: Configuration (select one)

->(01)<- Secure Only (factory default)

(02)1-Line Dual-Mode

(03)2-Line Dual-Mode

Entering the Default Settings mode is done by pressing and holding the Reset button on the side of the 90si for five (5) to six (6) seconds until both Green and Red lights extingush. Releasing the Reset button at this point will place the 90si into the Default Settings mode as evidenced by the Green light extinguished and the Red light il- luminated. Changing the default protocol is then done using the attached fax machine's handset (or Hook button) and dialpad by dialing the two-digit code(s) of the setting(s) you wish to turn on or activate. The Secure Telep- none / Crypto should be idle (not in Secure Data Mode). After dialing the two-digit code(s), hang up the fax to exit the Default Settings mode. The Green light will blink a number of times and then illuminate steadily. The 90si is now ready to operate with your new Default Settings.

www.gwfs.com, 877-951-9800, info@gwfs.com help line: 877-951-9814 page 10