Spartan Operation and Maintenance Manual
4.0 Installation
GBC Films Group is committed to a program of ongoing product improvement. As a result, we are providing these instructions so that you can insure that your new Spartan Laminator is properly and securely unpacked, moved and installed.
Before a Spartan Laminator can be installed, there are a few requirements that must be met. Make certain that each of the requirements listed in the following pre- installation checklist are met before beginning installation.
CAUTION: Failure to follow the
WARNING: The operating environment must be free of dust, flammable liquids and vapors. You can be injured by inhaling chemical vapors.
WARNING: Vapor build up or stored flammable liquids can cause a fire. Excessive dust can damage the laminator.
CAUTION: Do not locate the laminator where air can blow directly on the machine. The air flow can cool the rollers unevenly and result in poor quality output.
4.1 Pre-installation
Are the doorways and hallways wide enough for the laminator to be moved to the installation site?
Is there ample room for the laminator?
A work area must be established that allows for unrestricted movement around the laminator and provides space for efficient material flow. Figure
4.1.4and Figure 4.1.5 illustrates a typical machine area layout.
Is the environment appropriate for the laminator?
The laminator requires a clean, dust and vapor free environment to operate properly. It must not be located where there is air blowing directly on the machine.
Have you contacted a certified electrician to install a receptacle for the laminator ensuring that adequate power is being supplied and correct circuit breaker?
US and Canada: The laminator requires 230- 240 vac, 60 Hz, 15 amps, single phase
Figure 4.1.1
N E M A 6 - 15P | N E M A 6 - 15R |
Europe: The laminator requires
Figure 4.1.2
16 receptacle
16 p lu g
© 2004 General Binding Corporation | Page |
