Spartan Operation and Maintenance Manual
1.Set the pressure handle to the roller release position and raise the cover.
2.Use a damp ( use water only to dampen the cloth ) white terry cloth towel to wipe dust from the upper roller.
3.For the lower roller, close the cover, press RUN to rotate the lower roller to a new area to clean.
1.Set the pressure handle to the roller release position and raise the cover.
2.With a rubber cement eraser or Scotch Brite TM gently rub the adhesive on the roller.
4. Repeat the steps above until the lower roller is cleaned CAUTION: Excessive pressure can destroy the
silicone layer by pressing too hard or scrubbing too long in one spot.
7.2.2 Adhesive on rollers
CAUTION: Hardened adhesive deposits on the rollers can cause damage to the rollers.
CAUTION: Do NOT pick or pull heat activated adhesive off the rolls when they are cold. You can cause irreparable damage to the laminating rolls.
CAUTION: The following procedure is performed while the laminator is HOT! Use extreme caution!
3.Use a damp (water only) white terry cloth towel to wipe adhesive beads off the roller.
4.For the lower roller, close the cover, press RUN to rotate the lower roller to a new area to clean.
5.Repeat the steps above until the lower roller is cleaned
Page | © 2004 General Binding Corporation |
