Spartan Operation and Maintenance Manual
6.2 Mounting boards
1.Turn the laminator on.
2.Center the image on the board under the protective sheet.
Protective sheet
Image
Board
3.Set the pressure handle to the foam pouch position.
4.Wait for READY to illuminate.
5.Press RUN.
+
7.Gently slide the mounting board into the roller nip until you feel the rollers catch the board.
8.Support the board as it exits the rear of the laminator.
9.Press STOP and set the pressure handle to the roller release position.
+
10.Pull the protective layer off the board and trim to desired size.
Protective layer
6.Align the leading edge of the mounting board slightly off center of the table.
Page | © 2004 General Binding Corporation |
