GE 1000 Limitations, Alarm System, Test, DONE, Done, Hours, Hours, Minutes, Clock Set, Clock Set, SYSTEM STATUS, Setting the Clock, Testing Communication

Note

If your system is not connected to a central monitoring station and you don’t use a pager, you won’t be able to perform the phone test.

Device	Do This
Shock Sensor	Tap the glass twice, away from the sensor. Wait at least
	30 seconds before testing again.
Smoke Sensor	Press and hold the test button until the system sounds
	transmission beeps.
Wireless Panic Button	Press and hold the appropriate panic button(s) for 3
	seconds.
Keychain Touchpad	Press and hold LOCK and UNLOCK simultaneously for
	3 seconds.
Remote Handheld Touch-	Press and hold the 2 EMERGENCY buttons simulta-
pad	neously for 3 seconds.
2-Way RF Touchpad	Press and hold the 2 EMERGENCY buttons simulta-
	neously for 3 seconds.
RF Electronic Thermostat	No trip needed.

Testing Communication

Communication between your system, the central monitoring station and your pager should be tested at least once per week to make sure you have the proper telephone connection.

￿To perform a phone test:

1.Open the panel cover.

2.Enter the master access code.

3.Press the Test button twice. The panel will announce Phone test, press again to change or done to select.

4.Press the DONE button.

The panel will announce Phone test is on at least twice. If the test is successful the panel will announce Phone test ok within 3 minutes. The panel will announce Phone test is on three times if you have a pager. If the phone test to the pager was successful, your pager will display -101-101. If the test is unsuccessful, the SYSTEM STATUS button will light and within 10 minutes the panel will announce Phone communication failure. If a phone test fails, call your security system dealer.

Setting the Clock

If the panel loses power, the clock must be set. The default setting is 12 hour mode.

Your installer can set the clock to 24 hour mode if you wish.

	1.	Open the panel cover. Panel announces, Use numbered keys to enter ID.
	2.	Enter the master access code. Panel announces, Please select from Start Menu.
	3.	Press Clock Set from the Start Menu. Panel announces, Time is ****, to change
		press hours and minutes, then press done.
	4.	Follow the arrow from the Clock Set button to the Hours keys.
	5.	Press the Hours +/– keys and listen to the voice prompts. Stop when panel voice
		announces the correct hour.
	6.	Press the Minutes +/– keys and listen to the voice prompts. Stop when the panel
		announces the correct minutes.
	7.	Press Done. The panel will announce the set time.
	8.	Close the cover.
Alarm System	Not even the most advanced alarm system can guarantee protection against burglary,
Limitations	fire, or environmental problems.
	All alarm systems are subject to possible compromise or failure-to-warn for a variety
	of reasons.

Security Pro 1000 25