Note

The panel needs to be armed to Doors & Windows and Motion Sensors for Options 81 and 82 to work. If there are no Motion Sensors in the system, the Motion Sensors button must still be pressed. When the system is disarmed both options default to off.

Note

RF Thermostat must be in Heat Mode or Auto Mode for the option to work properly.

Note

Heating and Cooling Set Points need to be programmed with a difference of at least 2 degrees for these Options 81 and 82 to work properly.

•AC Power Failures - An AC power failure is called in after loss of power. To avoid false alarms, your installer has programmed the panel to wait at least a few minutes (or up to several hours) before calling in.

•AC Power Restore - A restore will be reported when power is restored.

•Alarms - Alarm reports include: Emergency, Intrusion, and Fire.

Option 55: Status Sounds

Add allows you to set the volume for status sounds, such as arming beeps, trouble beeps, and status beeps. The lowest volume setting is 1, the highest is 10.

1.Open panel cover. Panel announces, Use numbered keys to enter ID.

2.Enter Access Code using the numbered keys. Panel announces, Please select from Start Menu.

3.Press Add from the Start menu. Panel announces, Select from main menu

4.Press Option #. Panel announces, Option 1, press again for next option or done to select.

5.Press 55. Panel announces, Option 55, press again for next option or done to select

6.Use the numbered keys to enter the desired volume setting (01-10).

7.Press DONE.

Delete sets the volume of status sounds to the default setting (7).

1.Open panel cover. Panel announces, Use numbered keys to enter ID.

2.Enter Access Code using the numbered keys. Panel announces, Please select from Start Menu.

3.Press Delete from the Start menu. Panel announces, Select from main menu

4.Press Option #. Panel announces, Option 1, press again for next option or done to select.

5.Press 55.

6.Press DONE.

Option 81: Heating Set Point

When this option is on you can set a temperature that will automatically turn the furnace on if the temperature falls below the set temperature. The commands are set through the control panel, to the RF Electronic Thermostat, when the system is armed to Doors & Windows and Motion Sensors.

Add allows you to set the temperature from 51°F - 91°F.

1.Open panel cover. Panel announces, Use numbered keys to enter ID.

2.Enter Master Code using the numbered keys. Panel announces, Please select from Start Menu.

3.Press Add from the Start menu. Panel announces, Select from main menu.

4.Press Option #. Panel announces, Option 1, press again for next option or done to select.

5.Press 81. Panel announces, Option 81, press again for next option or use num- bered keys to enter option.

6.Enter the temperature (51 - 91) with the numbered keys.

7.Panel announces the temperature that has been selected.

Delete disables the Heating Set Point feature.

1.Open panel cover. Panel announces, Use numbered keys to enter ID.

2.Enter Access Code using the numbered keys. Panel announces, Please select from Start Menu.

3.Press Delete from the Start menu. Panel announces, Select from main menu

Security Pro 1000

21