GE 162D6733P007 Preparing to install the refrigerator, Refrigerator Location, Clearances, Rollers

Installation Instructions OperatingInstructions SafetyInstructions

Preparing to install the refrigerator.

Read these instructions completely and carefully.

Water Supply to the Icemaker (on some models)

If the refrigerator has an icemaker, it will have to be	A water supply kit (containing copper tubing,
connected to a cold water line.	shutoff valve, fittings and instructions) is available
	at extra cost from your dealer or from Parts and
	Accessories, 800-626-2002.

Refrigerator Location

Do not install the refrigerator where the	Install it on a floor strong enough to support it
temperature will go below 60°F (16°C)	fully loaded.
because it will not run often enough to maintain
proper temperatures.

Clearances

Allow the following clearances for ease of	If the refrigerator is against a wall on either side,
installation, proper air circulation and	allow the following door clearances:
plumbing and electrical connections:	19′–25′ models	3/4″ (19 mm)
Sides 5/8″ (15 mm)
	27′ models	11/2″ (38 mm)

Top 1″ (25 mm)

If built-in, allow 7/8 ″ (22 mm) for hinge covers.

Back 1″ (25 mm)

TroubleshootingTips

CustomerService

Rollers

The rollers have 3 purposes:

1 Rollers adjust so the door closes easily when opened about halfway. [Raise the front about 5/8″ (15 mm) from the floor.]

To assure that the doors will close automatically from a halfway open position, there is a built-in tilt from the front to the back of the cabinet. Side-by- side refrigerators also have specially designed door hinges that lift both doors slightly when opened, allowing the force of gravity to help close them securely.

2 Rollers adjust so the refrigerator is firmly positioned on the floor and does not wobble.

3 Rollers allow you to move the refrigerator away from the wall for cleaning.

To adjust the rollers, remove the base grille by pulling it out at the bottom.

Turn the roller adjusting screws clockwise to raise the refrigerator, counterclockwise to lower it. Use an adjustable wrench (3/8″ hex head bolt) or pliers.

To replace base grille, align prongs on back of grille with clamps in cabinet and push forward until grille snaps into place.

14