Instructions
Care and cleaning.
Safety
In the Event of a Power Failure
If the power fails, open the door as infrequently as possible to maintain the temperature. A gradual rise in temperature should not have any adverse effect on the wine.
If it is extremely hot, you may want to unload the wine from the beverage center/wine chiller and move the wine
to a cooler location until power is restored.
The controls may maintain your temperature settings when the power has been restored. If your settings are not correct, reset according to the Control Settings section.
Instructions
Care and Cleaning
Operating
Troubleshooting | Tips |
Consumer Support
Preparing to Move
Unload the wine, then secure the racks by | Be sure the beverage center/wine chiller |
taping them in place to prevent damage. | stays in an upright position during the move. |
Replacing the light bulb.
Unplug the beverage center/wine chiller.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the beverage center/wine chiller near the back. To remove the light shield, remove the screw on the right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Light Shield | Unscrew the light bulb from the socket. |
Screw
Replace with a 15 watt, 120 volt bulb. This type of bulb is available at most hardware and automotive parts stores.
WARNING: Using a bulb rated higher than 15 watts may damage the electronic controls on the beverage center/wine chiller.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the beverage center/wine chiller.
8