•While the unit is receiving caller ID information, you cannot access the Memo mode.
MEMORY FULL
When the unit's memory is full, it picks up after
10rings. After a
REMOTE ACCESS
To enter Remote Access mode during or after the announcement, press the # button and then enter the correct security/user code. The unit emits another tone while it waits for you to enter one of 10 function commands. See Page 16 for commands.
After each function is performed, the unit emits the same tone. If no command is entered
after 20 seconds, the unit disconnects the line and returns to the Idle mode.
•The unit allows two attempts at entering the correct security/user code. If, after the second try, the security/user code is not correct, the unit disconnects the line and returns to the Idle mode.
To end the remote operation, hang up or press 3 on the phone for the Hang Up code.
Remember that when you play your messages by remote access, the Toll Saver feature resets the unit to answer on the 5th ring.
DISABLING REMOTE ACCESS
To disable remote access, set your security/ user code to 000. This also disables remote turn on and the ability to erase messages in the event the unit's memory becomes full.
15
