Installation Preparation – Hot Water Supply
Prepare Hot Water Supply
Hot Water Line
•The line may enter from either side, rear or floor within the shaded area shown in Figure F.
•The line may pass through the same hole as the electrical cable and drain hose, or cut an additional
CAUTION
The hot water supply line pressure must be at least 20 PSI. Lower pressures could cause the water valve to leak and cause water damage.
PRECAUCIÓN
La línea de presión del suministro de agua caliente debe ser al menos 20 PSI. Presiones inferiores podrían causar que la válvula del agua gotee y causar daños por agua.
| 4" | 5" 4" | |
| 5" | ||
|
|
| |
Hot | Valve |
|
|
|
|
| |
| 2" |
| 6" |
|
|
| |
| From | 19" From Wall |
|
Cabinet |
|
Cabinet Face
Figure F
2" From Floor
Water Line Connection
•Turn off the water supply.
•Install a hand
•The water connection is on the left side of the dishwasher. Install the hot water inlet line, using 3/8" or larger copper tubing. Route the line as shown in Figure F and extend forward at least 19" from rear wall.
•Adjust the water heater to deliver water between
120°F and 150°F.
•Flush water line to clean out debris. Use a bucket to catch water and debris.
•The hot water supply line pressure must be between 20 and 120 PSI.
6