Installation Instructions
•Do not installthe refrigerator where the temperature will go below 60°F(16°C) because it will not run often enough to maintain proper temperatures.
•Do not installthe refrigerator where the temperature will go above 100°F (37°C)because it will not perform properly.
•Install it on a floor strong enough to support it fullyloaded.
CLEARANCESAllow the followingclearances for ease of installation, proper air circulationand plumbing and electricalconnections.
Sides | 1/8″ (3 mm) |
Top | 1″ (25 mm) |
Back | 1″ (25 mm) |
REMOVING THE REFRIGERATORDOORS
•IMPORTANT NOTE:This refrigerator is 355/8″ deep.Doors and passagewaysleading to the installation location must be at least36″ wide in order to leave the doors and handles attached to the refrigerator whiletransporting it into the installation location.
If passagewaysareless than36″, the refrigerator doorsand handles can easily be scratchedand damaged. The top cap and doorscan be removed to allowthe refrigerator to be safely movedindoors. If passageways areless then 31″, the leveling legs must be removed as well.Start with Step 1.
•If it is not necessary to remove doors, skipto Step 11. Leave tape and all packaging on doors until the refrigerator is in the final location.
•NOTE: Use a padded hand truck to move thisrefrigerator. Place the refrigeratoron the hand truck witha side againstthe truck. We strongly recommend that
TWO PEOPLE moveand complete this installation.AREMOVING
THE DOOR |
| |
HANDLE: Loosen |
| |
the set screws with |
| |
the 3/32″ Allen | Badge | |
wrench | ||
and remove | A | |
the handle. |
| |
| Mounting | |
| Fasteners | |
Plastic handle: |
| |
A REMOVING |
| |
THE DOOR |
| |
HANDLE: Slide |
| |
the handle up |
| |
and off of | Badge | |
the mounting | ||
| ||
fasteners. |
| |
| A |
Mounting
Fasteners
NOTE: If the handle mountingfasteners needto be tightened or removed, use a
2REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:ALoosen the set screws located on the underside
of the handle with the 1/8″ Allen wrench and remove the handle.
NOTE:If the handle mountingfasteners needto be tightened or removed, use a
A
26