GE 45608 manual Important Notes on New Remotes

Notes on Network Management

1.“Add a node, group or scene” can also be referred to as “include a node, group or scene.” “Remove a node, group or scene” can also be referred to as “Exclude a node, group or scene.”

2.If the screen displays FAIL during the setup or programming process, you have pressed an invalid key or the desired action has not been successfully completed. Please try again.

Important Notes on New Remotes

New remotes are, by default, primary remotes (controllers). This means that a new remote can:

•Create a new control network.

•Be added to an existing network as a secondary controller.

•Be added to an existing network as the new primary controller. In this case, the original remote is converted into a secondary controller.

•Delete nodes from an existing control network and reset them to their factory defaults. If devices in an existing network are deleted by a primary controller that is not part of that network, the entire network may suffer reliability and control problems.

-The original remote will not be able to control those devices even though they are still listed in its device and routing tables.

-Devices that normally receive routed (relayed) command signals through the deleted devices may fail to operate as expected.

-A deleted device can be added back into the network with that network’s primary controller, however, the network’s controllers will indicated “failure” when attempting to use Group, Scene or All commands that include the deleted devices. In this situation, the only solution is to reset (delete) every device, reset the controllers and recreate the network.

23