GE 45608 manual Initial Setup Audio/Video Devices, Adding a Device by Entering Its Code

4.When in setup mode:

•Press and release the SET key to back up one level in the menu.

•Press and hold the SET key to exit setup mode.

With the remote in A/V mode, press & hold the SET Key

for the following menu options

Initial Setup

Advanced Functions

About

Z-Wave

Setup

Initial Setup (Audio/Video Devices)

Initial Setup

Add

Device

Change

Device

Code

View Code

Delete Device

Replace

Device

Note: Most devices can be added by entering its code or searching for its code as described in the following two sections. (Be sure the device you wish to add is turned on before adding or searching for its code.) You also have the option of using your device’s original remote to teach commands to this remote. This is covered in the “Advanced Functions” section under the “Learn Function” heading.

Adding a Device by Entering Its Code

You can add a device by manually entering its manufacturer’s code. See “Manufacturer’s Codes” on page 45.

1.Press and hold SET until the remote displays INITIAL SETUP.

2.Press OK. The remote displays ADD DEVICE. Press OK.

3.The bottom line of the display lists RECEIVER as the first device you can add. Press OK or use the ARROW keys to scroll to a different device to add and then press OK.

4.Enter the four-digit code for your device. The LED blinks once for each digit entry. It blinks twice after you have entered the final digit.

7