GE 45608 - page 39

To send device and network information to a

secondary remote:

1. Enter Z-Wave setup mode and highlight TRANSFER

2. Press OK; the screen will display CREATE SECONDARY

3. Press OK; the screen will display ALL

4. Place the Secondary remote in RECEIVE mode. See the

following section on “Receiving Network and Device

Information” if the Secondary remote is a GE 45608 remote.

If the Secondary remote is a different GE model or different

brand, please refer to its instructions for details.

5. After the Secondar y remote is in the RECEIVE mode press

OK on the Primary remote; the screen will display SENDING.

The Primary remote then transmits the network and device

information to the new Secondary remote.

6. Both remotes should indicate a successful comp letion of the

copying process.

a. The 45608’s screen will display SUCCESSFUL.

b. Other GE models or other brands will indi cate success in

various ways, depending on the remote’s capabilities. Please

refer to its instructions for details.

7. Change individual devices, groups, s cenes, etc. on the new

secondary remote as needed.

To send only network information to a secondary remote:

1. Enter Z-Wave setup mode and highlight TRANSFER

2. Press OK; the screen will display CREATE SECONDARY

3. Press OK; the screen will display ALL

4. Press the right arrow key once; th e screen will display

NETWORK ONLY.

5. Place the Secondary remote in RECEIVE mode. See the