ge.com
Safety |
Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling. Use the Temperature Increase ▲ / Decrease ▼ pads to set the desired temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
Cooling Descriptions
For Normal
For Maximum
For Quieter & Nighttime
temperature.
Do Not Operate in Freezing Outdoor ConditionsInstructions | |
Instructions | Operating |
NOTE: If the air conditioner is off and is then turned on | This |
while set to a Cool setting or if turned from a fan setting | freezing outdoor conditions. It must not be used in |
to a Cool setting, it may take approximately 3 minutes | freezing outdoor conditions. |
for the compressor to start and cooling to begin. |
|
Energy Saver Mode
Controls the fan.
Care and Cleaning |
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan | entered. The room temperature will appear | |
speed to provide air circulation and filtering | in the display. | |
without cooling. Since fan only settings do not | NOTE: Auto Fan Speed cannot be used when in the | |
provide cooling, a Set temperature cannot be | ||
Fan Only Mode. | ||
|
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically set to the speed needed to provide optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed will automatically increase. If the room needs less cooling, the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.
Air Direction
Use the levers to adjust the air direction left and right.
Fingertip pressure on the louver banks adjusts the air direction up or down.
Troubleshooting
Consumer
Tips
Remote Control
■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■The remote control signal has a range of up to 20 feet.
■Make sure nothing is between the air conditioner and the remote control that could block the signal.
■ Make sure batteries are fresh and installed | 5 |
correctly as indicated on the remote control. |
Support