Installation Instructions
1WINDOW REQUIREMENTS
•These instructions are for a standard
CAUTION: If the sill support bolts do not contact the window sill, or if you have a window without a sill, you must order accessory kit RAK87 to properly install this air conditioner.
Call 800.626.2002 or visit ge.com.
•The air conditioner can be installed without the accordion panels if needed to fit in a narrow window. See the window opening dimensions.
•All supporting parts must be secured to firm wood, masonry or metal.
•The electrical outlet must be within reach of the power cord.
15 1/2” min.
25 1/4″ to 38 1/8″
(With accordion panels)
2STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly. To adjust for this, attach a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2″
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece of wood on the sill to make it 1/2″ higher than the top of the storm window frame or the vinyl frame.
Attach securely with nails or screws provided by the installer.
| 1/2″ higher | |
| than vinyl frame | |
| (on some windows) | |
1/2″ higher | Wood | |
| ||
than storm |
| |
window | Sill | |
frame | ||
| ||
Storm window | Vinyl frame | |
frame | ||
|
9
3REMOVE THE AIR CONDITIONER FROM THE CASE
ARemove and save the 2 screws from the lower sides of the front grille.
FRONT
BGrasp the lower corners of the grille while pressing in on the case sides with your finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you more than 3″ or you may damage the tabs of the grille.
FRONT
CRemove the ground screw from each side of the case. Keep them in a safe location.
FRONT
DSlide the air conditioner from the case by gripping the base pan handle and pulling forward while bracing the case. Do not pull or lift on the styrofoam discharge area.
Do not pull or lift in this area— damage to the unit may result
FRONT