GE AS_06 Controls, Instructions Troubleshooting Tips, Customer Service, Remote Control, Display

About the controls on the air conditioner–models with touch pads.

Features and appearance will vary.

Safety Instructions

TIMER POWER

TIMER

OFF

TEMP

ENERGY SAVER

FAN HIGH MODE

COOL MED

ENERGY LOW SAVER

Operating

HIGH COOL on/off FAN

MED	FAN	CIRCULAIRE	MODE FAN
LOW			CIRCULAIRE

Air Conditioner Controls

Remote Control

Controls

Instructions Installation

ON/OFF Pad

Turns air conditioner on and off.

Display

Shows the set temperature or time remaining on timer.

MODE

Use to set the air conditioner to COOL or FAN mode.

Increase ▲ /Decrease ▼ Pads

Use to set temperature when in COOL mode or to set the time when using the timer feature.

FAN Pad

Use to set the fan speed at LOW, MED or HIGH.

CIRCULAIRE Pad

Turn on to provide continuous side-to-side air circulation.

For fixed side-to-side air direction, turn ON until the desired air direction is obtained, then turn it OFF.

ENERGY SAVER Pad

Controls the fan.

ON–The fan and compressor cycle on and off. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. Note: The fan will continue to run for a short time after the compressor cycles off.

OFF–The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

TIMER Pad

Turn on and use the INCREASE ▲ / DECREASE ▼ pads to set the number of hours you want the air conditioner to run before turning off automatically. You can set the timer to run for up to 24 hours. To cancel the timer, press the TIMER pad until the display time disappears.

Remote Control Signal Receiver

Instructions Troubleshooting Tips

Remote Control

■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

■The remote control signal has a range of up to 21 feet.

■Make sure nothing is between the air conditioner and the remote control that could block the signal.

■Make sure batteries are fresh and installed correctly–see the Care and Cleaning section.

5

Customer Service