GE EPM 3000P instruction manual 03.0, Computer Controlled Dedicated Alarm

Chapter 7 Global Meter Setup

7.5GROUP 0, FUNCTION 3 - PROGRAMMING PROCEDURE

ÖTo change the SYSTEM CONFIGURATION SWITCH settings, follow these steps:

NOTE: PRESS MAX/MIN/LIMITS, AT ANY TIME, BEFORE STORING THE LAST DIGIT OR SWITCH.

AC VOLTS

0. AI BI CI AI BI CI N N N B C A

AC AMPS

A B C N

MAX MIN LM1 LM2

MAX MIN

03.0

__ _

AC VOLTS

A B C A B C

I I I I I I N N N B C A

AC AMPS

A B C N

LM1 LM2

MAX/MIN PRINT LIMITS PROG

VOLTS AMPS

PHASE

NEXT

MAX/MIN PRINT LIMITS PROG

VOLTS

AMPS

PHASE NEXT

Step 1:

a.Enter Group Level of Programming Mode, (see Chapter 6).

b.Press MAX/MIN/ LIMITS until 0. appears in upper display.

c.Press VOLTS to activate the Group.

		03			I	AC VOLTS
						N N N B C A
						A B C A B C
						I I I	I I I
		__ _				AC AMPS
							A B C N
MAX MIN						LM1	LM2
	MAX/MIN		PRINT	VOLTS	AMPS	PHASE
	LIMITS		PROG			NEXT

Ö03.0 appears in upper display.

ÖLower display indicates current PACK 0 Switch Settings.

		03. I			AC VOLTS
					N N N B C A
					A B C	A B C
					I I I	I I I
_					AC AMPS
		_ _				A B C N
MAX MIN					LM1	LM2
	MAX/MIN	PRINT	VOLTS	AMPS	PHASE
	LIMITS	PROG			NEXT

Step 2:

a.Press PRINT/PROG until desired PACK appears.

b.Press VOLTS to begin Data Entry Sequence.

ÖThree dashes appear in lower display.

Step 3:

a.Press PRINT/PROG to toggle the segments UP or DOWN for desired setting.

b.Press VOLTS to store

See Chapter 12 to Exit.

7.6GROUP 0, FUNCTIONS 4-5 - TIME DELAY FOR RELAYS 1 & 2 (OPTION NL)

The EPM3000P can be equipped with a relay option. Two relays are included in this option. The relays can be used in computer controlled or dedicated alarm options.

COMPUTER

CONTROLLED

DEDICATED ALARM

The relays can be locked or unlocked through a computer (must have communication option).

The relays can be locked or unlocked using the meter's keypad or its measured inputs. The computer cannot change the state of the relay.

Under GROUP 0, FUNCTIONS 4-5, time delay for the Relays 1 or 2 can be set between 0 - 255 seconds. This allows conditions to exist for a specified time period before the relay or alarm activates. If a time greater than 255 seconds is entered, the meter defaults to the maximum value of 255 seconds.

26

GE Industrial Systems