GE GNSF48A01 Normal Operation, Timer Display, Feature Optional Recharge Controls, Recharge Now

Models: GNSF48A01 GNSF39A01

1 36
Download 36 pages 13.69 Kb
Page 15
Image 15
Normal Operation, Timer Display

Normal Operation, Timer Display

During normal operation, the present time of day and AM or PM show in the control display area. When the demand computer determines a regeneration is needed, RECHARGE TONIGHT begins to flash in the display along with the present time. RECHARGE TONIGHT flashes until the next regeneration start time, then changes to RECHARGE NOW, which flashes until the regeneration is over. The display also shows the current cycle in the regeneration process. When the valve is in transition between cycles, both indicators flash.

Feature: Optional Recharge Controls

RECHARGE TONIGHT

 

TOUCH

 

 

RECHARGE NOW

 

or

 

HOLD

 

 

Sometimes, a manually started regeneration (recharge) may be desired or needed. Two examples:

You have used more water than usual (house guests, extra washing, etc.) and you may run out of soft water before the next regeneration.

You did not refill the storage tank with salt before it was all gone.

Use one of the following features to start a regeneration immediately, or at the next preset regeneration start time.

RECHARGE NOW

Press and hold the TOUCH or HOLD button until RECHARGE NOW starts to flash in the control display area. The water softening system begins an immediate regeneration and, when over in about two hours, you will have a new supply of soft water. Once started, you cannot cancel this regeneration.

RECHARGE TONIGHT

Touch (do not hold) the TOUCH or HOLD button. RECHARGE TONIGHT flashes in the control display area. A regeneration will occur at the next preset regeneration start time. If you decide to cancel this regeneration, touch the same button once more.

Feature: Program Memory

If electrical power to the water softening system is interrupted, the control display is blank, but the control keeps correct time for about 72 hours. When power is restored, you have to reset the present time only if the display is flashing. All other settings are maintained and never require resetting unless a change is desired.

If the time is flashing after a long power outage, the water softening system continues to work as it should to provide you with soft water. However, regenerations may occur at the wrong time of day until you reset the control to the correct time of day.

15

Page 15
Image 15
GE GNSF48A01 Normal Operation, Timer Display, Feature Optional Recharge Controls, Feature Program Memory, Recharge Now