Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
• CAUTION – Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet.
2
REMOVE THE OUTLET COVER
•Remove the outlet cover
with a
SideBack
TOOLS YOU WILL NEED
Flat blade and Phillips | Pliers |
screwdrivers |
|
PARTS INCLUDED
1 |
|
|
| 2 | 3 |
NO. | DESCRIPTION | QUANTITY |
1 | Water Fill Tube | 1 |
2 | Ice Fill Guide | 1 |
3 | Water Fill Tube Seal | 1 |
1INSTALL FILL TUBE
• If the refrigerator already has a water tube inlet on the back of the refrigerator, go to Step 2.
• Remove and discard the white plug
from the lower left back corner of Remove plug
the freezer wall.
•Go to the back of the refrigerator. Find the small label in the upper right hand corner and peel it off. Then discard the label.
• Peel one side of the paper away | Seal | |
from the water fill tube seal, slide | ||
| ||
the seal along the tube and affix |
| |
to the back side of the water |
| |
tube inlet flange. |
|
• Remove the adhesive backing on the opposite side
of the water fill tube seal and
slide the tube into the hole 
near the top at the back of the refrigerator. Firmly press on the inlet to secure it to the refrigerator.
3 PREPARE FOR INSTALLATION
Inside the freezer, loosen the two mounting screws, but do not screw them all the way out. If your model does not have the screws already in the freezer wall, look for two plug buttons. Remove the plug buttons and insert the two Phillips head screws. The screws should extend approximately 1/2″ (13mm) out from the freezer wall.
Mounting screws
4SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave the power switch in the O (off) position until the refrigerator is connected to the water supply to prevent premature operation.
Hole for
wire tie
Power 
Switch
(Appearance may vary)
13
