Installation Instructions
8REHANG THE REFRIGERATOR
DOOR
Lower the refrigerator door onto the bottom hinge pin.
Plastic
Washer
Screw the two screws into the center hinge location on the left side with a 5/16″ socket and ratchet.
Straighten the door and place the center hinge pin into the opening on top of the door. Remember to include the washer.
Move the door into place, so you can align the center hinge bracket over the center hinge holes on the left side. Insert and tighten the two screws with a 5/16″ socket and ratchet.
NOTE: Ensure the washer is in place on top of the hinge pin.
Plastic Washer 
Hinge Pin
Center Hinge
Bracket
Refrigerator Door
9REHANG THE FREEZER DOOR
Lower the freezer door onto the center hinge pin.
Be sure the washer is in place.
Center Hinge Pin
Plastic 
Washer
Lift the top hinge so the pin fits into the door socket.
Support the door on the handle side and make sure the door is straight and the gap between the doors is even across the front. While holding the door in place, tighten the top hinge screws.
10 ADJUST THE DOORS (IF NEEDED)
If the freezer door is too high:
Remove the hinge |
|
cover on top of the | Loosen screws. 5/16″ |
freezer door and |
loosen the four screws with a 5/16″ socket and ratchet. Replace the hinge cover.
If both doors are too high:
1.Remove
the hinge
cover on | Loosen screws. 5/16″ |
top of the |
|
freezer |
|
door and | 5/16″ |
loosen the | |
four screws |
|
with a | Loosen |
″ | screws and |
5/16 |
|
socket and | slide left to | |
lower doors. | ||
ratchet. | ||
|
2.Loosen the two center hinge screws with a 5/16″ socket and ratchet.
3.Slide the center hinge to the left to lower the doors.
4.Fully tighten all screws and replace top hinge cover.
If both doors are too low:
1.Remove the
hinge cover
on top of | Loosen screws. 5/16″ | |
the freezer |
| |
door and |
| |
loosen the | 5/16″ | |
four screws | ||
with a 5/16″ |
| |
socket and | Loosen | |
ratchet. | ||
screws and | ||
2. Loosen the | ||
slide right to | ||
two center | raise doors. |
hinge screws
with a 5/16″ socket and ratchet.
3.Slide the center hinge to the right to raise the doors.
4.Fully tighten all screws and replace top hinge cover.
NOTE: Save the door spacer.
Doors may settle with use.
Door Spacer
25
