Oven Shelves
Clean the shelves with an abrasive cleanser or steel wool. After cleaning, rinse the shelves with clean water and dry with a clean cloth.
NOTE: Take the shelves out of the oven before you begin the
Oven Light Replacement
Safety Instructions Operating
Wire cover holder.
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a
To remove:
Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.
Do not remove any screws to remove the cover.
Do not touch hot bulb with a wet cloth. Replace bulb with a
To replace cover:
Place it into the groove of the light receptacle. Pull the wire forward to the center of the cover until it snaps into place. When in place, the wire holds the cover firmly. Be certain the wire is in the depression in the center of the cover.
Connect electrical power to the range.
Instructions Installation Instructions
Fluorescent Top Light
CAUTION: Do not touch the bulb with wet hands or when the bulb is hot. Never wipe the light area with a wet cloth. Electrical power must be shut off if you have to replace the bulb.
Raise the clips on the back, on both sides, and free the back of the canopy.
Roll the canopy up and off.
Remove the fluorescent light bulb. Replace the bulb with one of the same length and wattage.
Replace the canopy by placing the front in the groove and rolling it back. Snap it into place over the back clips on both sides.
39
