GE JGBP24GE warranty ovenshelves, RenlovabieovenDoor

ovenshelves

Oven shelvesmay be cleaned with

amild abrasivecleanser following manufacturer’sdirections. After cleaning, rinse the shelveswith clean water and dry with a clean cloth. Toremoveheavy,burned-on soil, soapy metalpads may be used followingmanufacturer’sdirections. Afier scrubbing, wash with soapy water, rinse and dry,

oven Light Bulb

Youcan remove the oven bottom to clean anyexcessivespilloversbefore startingihe self-clea; ing cycle.

To remove the oven bottom:

1. Removethe oven shelves.

/

RenlovabieovenDoor

The ovendoor is removableto make the interior more accessibleduring the replacementof the lamp bulb,

.—

‘7

Open the ovendoor fully and removethe two Philips screwsthat

The light bulb is located in the upper left corner of the oven. Before replacing the bulb, disconnect electric power to the range at the main fuse or circuit breaker panel or unplugthe range from the electric outlet. Let the bulb cool completely before removing it. Do not touch a hot bulb with a damp cloth as the bulb will break.

To remove: Hold hand under lamp bulb cover so it doesn’t fall when released. With fingers of same hand, firmly push down wire bail until it clears cover. Lift off cover.

DO NOT REMOVE ANY SC~WS

~REMOVE THIS COVER.

Replace bulb with a 40-watt home appliance bulb.

To replace cover: Place cover into groove of lamp receptacle. Lifi wire bail up to center of cover until it snaps into place. When in place, wire holds cover firmly. Be certain wire bail is not below depression in center of cover.

2.Removethe two knurled hold- down screws at the rear of the oven. If they are too tight to remove by hand, use a coin or a screwdriver.

3.To lift out the oven bottom, placeyourfingers in the slots in the bottom and lifi the rear of the oven bottom up and back until the oven bottom is clear of the lip at the front.

4.Then lift the bottom up and out. To replace the bottom, place it in the oven with the back raised about

6to 8 inches or until you can insert the front of the oven bottom under the hold-down lip at the front. Then push the back of the oven bottom down fully into place on the metal flanges and insert the hold-down screws.

hold the door to the hinges. Then close the door to the automaticstop position (at about 3 inches open), and lift the door straight up and off the hinges. (Due to the large amount of insulation and the construction of the door, it is heavy.)

Note: Care should be taken not to place hands between the spring hinge and the oven door frame as the hinge could snap back and pinch fingers.

To replace the door, make sure the hinges are in the “out” position. Position the slots in the bottom of the door squarely over the hinges. Then lower the door slowly and evenly over both hinges at the same time. If hinges snap back against the oven frame, pull them back out. ‘Whenthe door is in position, open it fully and.insert the two Philips screws.