~STALLATION
~STRUCTIONS

HOW TO CONVERT THE RANGE FOR USE

WITH

1P

GM

OR

NATURAL

GM

TOOLS REQUIRED:
T-10 Torxdriver (for sealed burners)
1/2” and 3/4” open-end wrench
Flat blade screwdriver (small)
Nut drivers or wrenches:
7mm
or 5/16”
(depending on the size of the spuds)
❑
PREPARE
RAHGE
FOR CONVERSION
(1) Turn off gas supply at the wall.
(2) Turn off
tie
electicd
power to the range.
If range has not yet been connected to gas supply,
or if flexible connection was made, range maybe
pulled out from the wall to make conversion easier.
❑
CONVERT THE PRESSURE REGULATOR
W~~G:
Do not remove the pressure
regulator from the range.
1. For models equipped with sealed burners,
remove the storage drawer, broiler drawer or
kick panel and locate the pressure regulator at
rear of the range.
f
(
Remove Screws
Access Cover
On some models, you may have to remove an
access cover also.
For models equipped with dual burners, remove
the
cooktop
and locate the pressure regulator at
right rear of range. ❑ 0
2. Follow the directions in
A
or B that match
your regulator type.
❑
Lever shown closed. Note: On some models the
~
ROTATE OPEN.
.—
If it is this regulator:
1. Use a coin to remove the cap from the
pressure regulator.
2. Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible
on the top of the cap.
❑
Note: On some models the shut-off valve
may be in a different location.
this protective cap ‘
Cap Assembly
except for conversion
If it is this regulator:
1. Unscrew the plastic-protected hex-nut cap
from the regulator.
2. Carefully pry the protective plastic cap off
the threaded metal cap. Gently pull the plastic
washer off the threads on the other side of the
metal cap.
3. Push the plastic
cap
onto the end of the metal
cap displaying the type of gas you are converting
to. Press the attached plastic washer onto the
threads on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator.
Do not overtighten.
42