CONVERTING TO LP GAS (Sealed Burner models only)
or Converting Back to Natural Gas from LP
3 CONVERTING SURFACE BURNERS
Grate
Burner Cap
Drip Pan
(on some models)
Burner Head
Electrode
1.Remove grates, burner caps and burner heads.
2. Remove the brass orifice spud inside the chimney of
each burner using a 9/32″ or 7 mm nut driver.
3. Install the orifice spuds Chimney according to one of the
following diagrams (see A or B ), for LP gas or natural gas, depending on which you are converting to.
Orifice spud
A Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed with this Use and Care Guide. LP orifice spuds have a
L | L |
L | L |
Front of Range
B Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds have a
N | N |
N | N |
Front of Range
4.To prevent leakage, make sure the orifice spuds are securely screwed into the gas inlet tubes.
5.Put old orifice spuds back in the bag to save for possible future conversion.
NOTE: If an orifice spud is accidentally dropped, the cooktop can be raised by releasing the 2 front clips with a large flat blade screwdriver.
When lowering it, make sure it snaps over the clips.
4 CONVERT THE OVEN BURNER ORIFICES
Oven Burner
1.Remove oven door, storage drawer and oven bottom. The lower burner orifice spud is located behind the storage drawer or kick panel. (On some models, a metal shield must be removed to access the orifice.)
2.To convert to LP gas,
″wrench to
use a 1/2
turn the lower burner orifice spud clockwise. Tighten the spud only until it is snug. To prevent damage, do not
overtighten the spud.
To convert to natural gas, loosen the spud about 2 turns.
(continued next page)
45
