GE JKP54, 164D2966P030 After Self-Cleaning, How to Set Delay Start of Cleaning, SET Stop Time

OPERATING THE SELF-CLEANING OVEN

(continued)

After Self-Cleaning

You may notice some white ash in the oven. Just wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are

usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

If the shelves have become hard to slide, wipe the shelf supports with cooking oil.

NOTE: No functions can be programmed before the door automatically unlocks.

How to Set Delay Start of Cleaning

Quick Reminder:

1.Prepare the oven for cleaning.

2.Close the oven door completely.

3.Press the CLEAN pad.

4.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

5.Press the STOP TIME pad.

6.Press the INCREASE or DECREASE pad until the desired Stop Time appears in the display.

Delay Start is setting the oven timer to start the clean cycle automatically at a later time than the presenttime of day.

NOTE: Before beginning, make sure the oven clock shows the correct time of day.

1.Follow steps to prepare the oven for cleaning.

2.Press the CLEAN pad.

CLEAN

n 3. Press the INCREASE or DECREASE A pad to enter the Clean Time.

~

4. Press the STOP TIME pad.

STOP	“SET STOP TIME” and the
	earliest Stop Time you can set
TIME
El will appear in the display.

The earliest Stop Time will be the Clean Time selected plus the time of day. For example: If the Clean Time is 3 hours and the time of day is 6:00, the Stop Time that appears in the display will be 9:00.

5.Press the INCREASE pad to change the Stop Time to a later time of day if desired. For example: If you set Stop Time at 11:00, the oven will start clean cycle at 8:00 and end at 11:00. The door latches automatically.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for the Clean cycle is set. The words “ON” and “LOCK” will appear in the display when the door automatically locks. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCK light goes off.

6.When the LOCK light is off, open the door.

NOTE:

●During a delayed self-clean operation you can find out when the oven is set to turn on by pressing and holding the CLEAN pad for 3 seconds.

●A fan may automatically turn on and off to cool internal parts. This is normal and the fan may continue to run even after the oven is turned off.

32