GE JVM131K, JVM130K warranty Cooktop Light, Oven Light, Circuit breaker panel or pull plug

Cooktop Light

To replace cooktop light, first disconnect power at main fuse or

Be sure bulbs to be replaced are cool before removing. Break

REMOVE SCREW

circuit breaker panel or pull plug.

the adhesive seal by gently unscrewing the bulbs. Replace

Remove screw on right side of light compartment cover and lower cover until it stops.

with 40-watt incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs (40S 1 lN/1), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)

WARNING–improper

use of the grounding plug can- result in a risk of electric shock.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with a 30-watt incandescent bulb (WB02X4235), available from your GE supplier.

PREFERRED

METHOD

@@

R+

Ensure proper ground

Fig. 1 exists before use

Consult a qualified electrician or

. . .- . . .

service tecnmclan lr the grounalng instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

Where a standard two-prong wall receptacle is encountered, it is your personal responsibility and obligation to have it replaced with

aproperly grounded three-prong wall receptacle.

Do not under any circumstance cut or remove the third (ground) prong from the power cord.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance.

29