Cooktop Light
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
I | REMOVE SCREW | |||||
|
|
|
|
| ||
To replace cooktop light, first disconnect power at main fuse or circuit breaker panel or pull plug.
Remove screw on right side of light compartment cover and lower cover until it stops.
Be sure bulbs to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs. Replace with
Oven Light
To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.
Next, remove the single screw located above door near center of oven that secures light housing. Replace
Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)
use of the grounding plug can result in a risk o~electric ~hoc~.
| INSURE PROPER |
| GROUND EXISTS |
Fig. 1 | BEFORE USE |
|
Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
Where a standard
aproperly grounded
Do not under any circumstance cut or remove the third (ground) prong from the power cord.
