GE JVM141K, JVM140K, JVM142K Cooktop Ligh~ight Light, Oven Light, or pull plug

Cooktop Ligh~ight Light

To replace combination cooktop lighti night light, first disconnect power at main

fuse or circuitREMOVE SCREW breaker panel

or pull plug.

Remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs to be replaced are cool before removing.

Break the adhesive seal

by gently	\
unscrewing	the

bulbs. Replace with 40-watt incandescent bulbs (WB02X4253) available from your GE supplier.

High intensitv 40-watt bulbs (40S1 lN/1), which are

. . ---- ..

~v~a~in s-upelm—tike”K”a-n-dtiar&w-tie stores, Lay also be used for replacements. Raise light compartment cover and replace screw. Connect

electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with a 30-watt incandescent bulb (WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

29