Element Hot Light Troubleshooting
Each element's hot light limiter switch and its wiring can be tested without removing the cooktop from its installation. This test will aid the service technician in determining if the element should be replaced. This test assumes the elements heat properly.
All circuits below element's glass top temperature of 150°F (66°C) should test open. If circuit tests 0 resistance, replace element.
All circuits above element's glass top temperature of 150°F (66°C) should test 0 resistance. If open, check wiring and replace element, if necessary. Operate element, if necessary, then disconnect power before testing cooktop.
Model PP 945 | Test Location |
Left Rear Element* | RPSM J2 to |
Left Front Element* | RPSM L1 to |
Right Front Element* | RPSM L1 to |
Right Rear Element* | RPSM J2 to |
Model PP 975 | Test Location |
Left Rear Element* | RPSM L1 to |
Left Front Element* | RPSM L1 to |
Center Element* | RPSM L1 to |
Right Front Element* | RPSM L1 to |
Right Rear Element* | RPSM L1 to |
* Requires opening the drop box.
– 22 –