GE PVM9179 owner manual Replacing the light bulb, Cooktop Light/Nite Light, Door Seal, Bottom

GEAppliances.com

Plastic Color Panels

Use a clean, soft, lightly dampened cloth, then dry thoroughly.

Door Seal

It’s important to keep the area clean where the door seals against the microwave. Use only mild, non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.

Bottom

Clean off the grease and dust on the bottom often. Use a solution of warm water and detergent.

Replacing the light bulb.

P

Remove screw.

P

Cooktop Light/Nite Light

Replace with a 120 volt, 40 watt (max.) halogen bulb. Order WB08X10051 from your GE supplier.

1 To replace the cooktop light/nite light, first disconnect the power at the main fuse or circuit breaker panel, or pull the plug.

2 Remove the screw from the side of the light compartment cover and lower the cover until it stops.

3 Be sure the bulb is cool before removing. Break the adhesive seal by gently unscrewing the bulb.

4 Screw in the new bulb, then raise the light

cover and replace the screw. Connect electrical power to the oven.

27