Replacing the light bulb.
Remove screw.
Cooktop Light/Night Light
5HSODFHZLWKDYROWRUZDWWPD[
KDORJHQEXOE2UGHU:%;IURP\RXU GE supplier.
1 To replace the cooktop light/night light, first disconnect the power at the main fuse or circuit breaker panel, or pull the plug.
2 Remove the screw from the side of the light compartment cover and lower the cover until it stops.
3 Be sure the bulb is cool before removing. Break the adhesive seal by gently unscrewing the bulb.
4 Screw in the new bulb, then raise the light
cover and replace the screw. Connect electrical power to the oven.
About the exhaust feature.
Charcoal filter (on some models). | Vent Fan | ||||
|
|
|
|
| The vent fan has two metal reusable vent filters. |
|
|
|
|
| Models that recirculate air back into the room |
|
|
|
|
| also use a charcoal filter. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Reusable vent filters
(on all models).
Reusable Vent Filters
The metal filters trap grease released by foods on the cooktop. They also prevent flames from foods on the cooktop from damaging the inside of the oven.
For this reason, the filters must always be in place when the hood is used. The vent filters should be cleaned once a month, or as needed.
Removing and Cleaning the Filters
To remove, slide them to the rear using the tabs. Pull down and out.
To clean the vent filters, soak them and then swish around in hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots on the back of each opening. Press up and to the front to lock into place.
24