![](/images/new-backgrounds/1076881/768817x1.webp)
Operating Instructions Safety Instructions
About the controls on the refrigerator.
Control Settings
Initially, set the control(s) at 5 (some models have only one control). Allow 24 hours for the temperature to stabilize.
Several adjustments may be required. Adjust the control(s) one increment at a time and allow 12 hours after each adjustment for the refrigerator to reach the temperature you have set.
Setting the refrigerator control to 0 stops cooling in both the freezer and refrigerator compartments but does not shut off electrical power to the refrigerator.
The freezer control (on some models) has no effect on electrical power to the refrigerator.
Control settings will vary based on personal preferences, usage and operating conditions, and may require more than one adjustment. Factors that affect temperature include the amount of food in the refrigerator or freezer, the frequency of door opening and the temperature of food when it is placed in the refrigerator.
About the water filter. (on some models)
Tips Installation Instructions
Water Filter Cartridge
The water filter cartridge is
located inside the cartridge holder in the back upper right corner of the refrigerator
compartment.
NOTE: Some models ship with the filter bypass plug in place of the
filter cartridge. The filter bypass plug needs to be removed before the filter cartridge is installed. Keep the filter bypass plug for future use.
When to Replace the Filter
The filter cartridge should be replaced every six months or earlier if the flow of water to the icemaker and dispenser decreases.
Filter Bypass Plug
You must use the filter bypass plug when
a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug.
Replacement Filters
To order additional filter cartridges in the United States, visit our Website, ge.com, or call GE Parts and Accessories, 1.800.661.1616.
Filter Model GSWF
Suggested Retail Price $34.95 USD
Customers in Canada should consult
the yellow pages for the nearest Mabe Service Center.
Troubleshooting
Installing the Filter Cartridge
Consumer Support
If you are replacing the cartridge, first remove the old one. To open the cartridge cover, push in where indicated and the cover will drop down.
4
Remove the cartridge by slowly rotating it to the left. A small amount of water may drip down.
CAUTION: If air
has been trapped in the system, the filter cartridge may be ejected as it is removed. Use caution when removing.
Apply a month and year sticker to the new cartridge to remind you to replace it in six months.
Position the cartridge inside the cartridge holder and slowly rotate the cartridge to the right until it stops. When the cartridge is properly installed, you will feel it “click” as it locks into place. The blade on the end of the cartridge should be positioned vertically. Do not overtighten.
Close the cartridge cover.
Run water from the dispenser for 3 minutes (about 11⁄2 gallons) to clear the system and prevent sputtering. See To Use the Dispenser section.
NOTE: A