Door Swing optional setting Scale

Design Guide

Refrigerator

Case Trim

Frameless Cabinets: The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing. The opening must allow for filler strips.

Door

Top View

90° DOOR SWING (optional setting) Scale 1:1

23-7/8" From Rear of Refrigerator

1/4"

1/2"

3/4"

1-1/4"

1-1/2"

Stainless Steel

	1/4"	3/4" Overlay
	1/4"	Panel
		Panel
		(Nominal Size)
		1/2"

3/4"

1-1/4"

Page 5

Image 5

GE ZICP720 installation instructions Door Swing optional setting Scale

Contents

Installation Instructions Before YOU Begin Contents Installation Space Dimensions and Clearances Overlaps cabinets at the top and sides Frameless Cabinets The case trimFiller strips to prevent interference with Cabinet door swing. The opening must Door Swing optional setting Scale Hardware Supplied Tools RequiredTrim Supplied Materials Required Shut off the main water supply Install Water LinesRemove Packaging Skip this step if you are not using side panels Install NEW Side TrimInstall Side Panels Brackets Required Block Install ANTI-TIP Brackets Push Refrigerator Into Opening Receptacles. Reach into the top opening Bracket Level the RefrigeratorsPlace a level inside the machine for each unit Drawers should be evenly aligned Install Grille Panel Alternate ANTI-TIP ProcedureTWO People are Required to Install Grille Panel Secure Refrigerator to Cabinetry Adjust Door Swing Install Center Trim Strip Skip this Step if Doors are Level Check and Correct Door AlignmentClose the grille panel and both doors LH Door Install Dim. a LH Spacer RH Spacer RH Door Install Dim. a LH Spacer RH SpacerDetermine Correct Spacer RH Fresh Food door is higher than the LH door Remove Pin Screws Connect Water Supply Install Grille Base WrapCopper Tubing GE SmartConnect Tubing Start Icemaker Connect PowerInstall Toekick Page GE Consumer & Industrial