GE ZICP720 Remove Packaging, Install Water Lines, Shut off the main water supply, Cautiondo Not

Installation Instructions

1 REMOVE PACKAGING

CAUTION: Refrigerator is much heavier at the top than at the bottom—be careful when moving. When using a hand truck, handle from side only.

PRUDENCE : Le réfrigérateur est beaucoup plus lourd en haut qu'en bas. Il faut être prudent lors des déplacements. Si un diable est utilisé, il faut soulever le réfrigérateur sur le côté seulement.

•Carefully cut banding at the top and bottom, remove outer carton.

•Slide out back corner posts (2).

•Slide carton off top of cabinet.

NOTE: IT IS NOT NECESSARY TO LAY CABINET DOWN IN ORDER TO REMOVE SKID!

•The unit is secured to the skid with 4 slotted tie-down straps. Remove the four 5/16″ bolts from the base channels in the tie-downs.

• Remove the four 7/16″ bolts securing the straps to the skid.

CAUTION:DO NOT

ATTEMPT TO ROLL UNIT

Remove OFF SKID.

Tie-Downs PRUDENCE :

IL NE FAUT PAS ESSAYER

DE FAIRE ROULER LE

RÉFRIGÉRATEUR POUR

L'ENLEVER DE LAY PALETTE.

•Support blocks on the bottom of the refrigeration case must be removed before the refrigerator is taken off the skid or damage will occur. Carefully tilt refrigerator and slide blocks out from beneath.

•Remove the tape from the leveling legs.

•Lift the refrigerator off the skid with an appliance dolly. Handle from the sides.

2 INSTALL WATER LINES

•A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120 p.s.i.

•Route 1/4″ OD copper or GE SmartConnect™ plastic tubing between house cold water line and the water connection location.

•Tubing should be long enough to extend to the front of the refrigerator. Allow enough tubing to accommodate bend leading into the water line connection.

NOTE: The only GE approved plastic tubing is supplied in the GE SmartConnect™ Refrigerator Tubing kits. Do not use any other plastic water supply line because the line is under pressure at all times. Other types of plastic may crack or rupture with age and cause water damage to your home.

GE SmartConnect™ Refrigerator Tubing Kits are available in the following lengths:

2′ (.6 m) WX08X10002

6′ (1.8 m) WX08X10006

15′ (4.6 m) WX08X10015

25′ (7.6 m) WX08X10025

Shut off the main water supply.

Turn on the nearest faucet long enough to clear the line of water.

•Install a shut-off valve between the icemaker water valve and cold water pipe in a basement or cabinet. The shut-off valve should be located where it will be easily accessible.

Floor

Waterline Tubing

•Turn on the main water supply and flush debris. Run about a quart of water through the tubing into a bucket. Shut off water supply at the shut-off valve.

NOTE: Saddle type shut-off valves are included in many water supply kits. Before purchasing, make sure a saddle type valve complies with your local plumbing codes.

NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts. Consult with your licensed plumber.

If the water supply to the refrigerator is from a Reverse Osmosis Water System, use the refrigerator’s filter bypass plug. Using the refrigerator’s water filtration cartridge with the RO filter can result in hollow ice cubes.

Filter Bypass Plug

7