Pioneer DEH-P8950BT Selecting the display language, Setting the date, Setting the clock

	Black plate (43,1)
	Section
Operating this unit	02

#You can also select the function by pressing FUNCTION on the remote control.

#To cancel initial settings, press BAND.

#You cannot select BT AUDIO when the Blue- tooth audio player has been connected.

Selecting the display language

For your convenience, this unit equips multi- ple language display. You can select the lan- guage best suited to your first language.

1Use MULTI-CONTROL to select Language select.

2Press MULTI-CONTROL to select the lan- guage.

Each press of MULTI-CONTROL selects lan- guages in the following order: English—Español—Português

2Push MULTI-CONTROL left or right to select the segment of the clock display you wish to set.

Pushing MULTI-CONTROL left or right will se- lect one segment of the clock display: Hour—Minute

As you select segments of the clock display the segment selected will blink.

3Push MULTI-CONTROL up or down to put a clock right.

Note

You can match the clock to a time signal by pressing MULTI-CONTROL.

!If the minute is 00 to 29, the minutes are rounded down. (e.g., 10:18 becomes 10:00.)

!If the minute is 30 to 59, the minutes are rounded up. (e.g., 10:36 becomes 11:00.)

English

Setting the date

The calender display adjusted in this mode ap- pears when the telephone source is selected or sources and the feature demo are off.

1Use MULTI-CONTROL to select Calendar.

2Push MULTI-CONTROL left or right to select the segment of the calendar display you wish to set.

Pushing MULTI-CONTROL left or right will se- lect one segment of the calendar display: Day—Month—Year

As you select segments of the calendar dis- play the segment selected will blink.

3Push MULTI-CONTROL up or down to set the date.

Setting the clock

Use these instructions to set the clock.

1 Use MULTI-CONTROL to select Clock.

Setting the FM tuning step

The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz.

!If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again.

1Use MULTI-CONTROL to select FM step.

2Press MULTI-CONTROL to select the FM tuning step.

Pressing MULTI-CONTROL repeatedly will switch the FM tuning step between 50 kHz and 100 kHz. The selected FM tuning step will appear in the display.

Setting the AM tuning step

The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable).

En 43

<CRD4206-A/N>43