GE PSB1201SS, ZSC1201SS Installation Preparation, Preparation WITHan Accessory Storage Drawer

Installation Preparation

Preparation WITH an Accessory Storage Drawer

NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″.

MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.

PREPARE THE OPENING (cont.)

Installation beside another GE/Monogram Built-in Speedcook Oven:

•If you are mounting one Under-the-Counter GE/Monogram oven beside the other, use

the dimensions shown. The middle rail separating the two openings may need to be larger than the 4-1/2″minimum shown.

21″

25-1/4″

23-1/2″

25-1/4″

21″

4-1/2″Min.

(5-1/2″Recommended)

PREPARE THE OPENING (cont.)

Installation under a GE Profile 30″ or 36″ Cooktop or Countertop:

Gas or electric cooktops may be installed
over this oven. See cooktop installation
instructions for the cutout size. See the			Cooktop
label on top of the oven for approved
cooktop models. This oven requires
a separate, properly
grounded 15-Amp,
120-Volt, 60Hz power
supply. The cooktop
requires a separate power
supply. Use a 36″ or wider
base cabinet .
IMPORTANT:
		23-1/2″
For Profile models only.
The Monogram oven
and drawer combination
cannot be installed below
a countertop.
	4″ High
	Toekick

1-1/2″Min.

25″

Cooktop

36″

Countertop

Height

25-1/4″ 21″

Cooktop height including depth of electrical box on some models. Refer to cooktop installation instructions.

No minimum clearance required between cooktop and oven.

NOTE: The oven is only approved to be installed under the specific models as labeled on the unit.

12