ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN
1REMOVE PACKAGING AND PARTS
•Remove the drawer from the carton.
•Remove all packing material and tape.
•Open the drawer and remove any parts inside.
•Locate parts.
Side Supports (2)
Assembly Instructions
Mounting Bracket
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Screws |
|
|
|
| ||||
| (6 required, |
|
| Screws |
| 2 extra) |
|
| (4 required, |
|
|
|
| 1 extra) |
|
|
|
| |
|
|
|
|
|
2UNDER-THE-COUNTER (UTC) MOUNTING BRACKET INSTALLATION
NOTE: For UTC models PSB1200, PSB1201 and ZSC1201 only.
AOpen the accessory drawer so you have access to the top bracket .
BRemove the three screws securing the top bracket .
CInstall the new UTC mounting bracket using the screws removed previously.
3 ASSEMBLING THE OVEN TO DRAWER
APlace storage drawer on a surface with the front of drawer hanging over the edge of the surface. Not placing the front edge of drawer over the edge of the surface may result in damage to the drawer since the front edge of drawer hangs below the bottom
of drawer.
BPlace the oven on top of the storage drawer. Make sure that the back and sides of the oven align with the back and sides of drawer.
NOTE: The bottom of the oven side flanges will sit directly in front of the top of the storage drawer side flanges.
D
Close the drawer and proceed with the installation.
17
