GE TOOLS AND MATERIALS REQUIRED, INSTALL THE WALL SUPPORT PANELS, from 30" Min. to 36" Max. height, ACCESSORIES—30"TO 36" ADJUSTABLE BACKSPLASH (not included)

ZXADJB30PSS,ZXADJB36PSS,ZXADJB48PSSAccessoryInstallation

ACCESSORIES—30" TO 36" ADJUSTABLE BACKSPLASH (not included)

WARNING:

To prevent ignition of combustible materials, the entire back wall above the range must be protected by a backsplash constructed of non-combustible material.

BEFORE YOU BEGIN

Read these instructionscompletely and carefully.

IMPORTANT: Save theseinstructions for local inspector’s use.

IMPORTANT: OBSERVEALL GOVERNINGCODES AND ORDINANCES.

NOTE TO INSTALLER: Be sureto leave these instructionswith the Consumer.

NOTE TO CONSUMER: Keepthese instructions withyour Owner’s Manual for future reference.

• This backsplash adjusts to fit the spacebetween

the top of the range and the bottomof the hood,

from 30" Min. to 36" Max. height.

INSTALL THE WALL SUPPORT PANELS

WARNING: The wall support panels must be securely fastened to the wall. Failure to do so could result in damage or personal injury.

IMPORTANT: This backsplash is designed to coverthe wall between the bottom of the hood and the top of the range. The vent hood should be installed over the rangetop or range before installing this backsplash.

•Install and level the Range/Rangetop according to the product installation instructions.

•Remove backsplash packaging and protective film.

•Locate wall studs on each side. Where studs are not available, plan to use wall anchors (not provided).

•Use a level to pencil 2 horizontal lines on the wall,

one 1/8" below the vent hood and the other 1/8" above the Range/Rangetop. This 1/8" space allows the cover panels to overlap the wall supports.

•Secure the top wall support panel to the wall with 4 wood screws, through the outermost studs.

•Use 4 wood screws to secure the bottom wall support panel. The center slot should be positioned at the top.

The gap between the top and bottom support panels will be covered by the top cover with shelf.

• Maximum shelf load-bearing weight is 40 lbs.

TOOLS AND MATERIALS REQUIRED

•Glovesto protect againstsharpedges

•T-15 and #2 Phillips screwdrivers

• Drill with 3/32" and 9/64" bits			Top Wall
			Support
•	Safety glasses
•	Level	Top Cover
•	Pencil	with Shelf

This Kit Includes

•	Top wall support
•	Bottom wallsupport	Bottom Cover
• Top cover with shelf
•	Bottom cover	Bottom Wall Support
•	Hardware package with

–9 Stainless Steel Torx15 #8 self-tappingscrews

– 9 Phillips#2 pan head wood#10 screws

– 3 Stainless Steel #2 trusshead

Hardware

#10 screws (for alternatePackage installation method)

1/8″

Center Wood

Arrow Screws Wood Screws

1/8″

Secure the top panel to the wall with 4 wood screws

Secure

the bottom panel to the wall with 4 wood screws

13