Installation Preparation

TOOLS REQUIRED

 

Drill and

Saber Saw

Appropriate Bits

 

Measuring Tape

Adjustable Wrench

 

 

1/4" Driver or Wrench

Carpenter’s Square

 

Safety Glasses

Phillips #2 Screwdriver

Level

Hand Truck

 

MATERIALS PROVIDED

Hold-Down

Regulator

Strap

 

MATERIALS REQUIRED (not provided)

Joint

Pipe Fittings

Shut-Off Valve

Sealant

 

 

5-foot maximum length, 5/8" O.D. CSA-approved

flexible metal gas supply

(3-foot maximum length in Massachusetts only) NOTE: Purchase new flexible line; do not use previously used flexible gas line.

POWER SUPPLY LOCATIONSGas Supply:

•The natural gas models are designed to operate at 5" water column pressure. For proper operation, the pressure of the natural gas supplied to the regulator must be between 7" and 13" water column.

•The LP models are designed to operate at 10" water column pressure. For proper operation, the pressure

of the LP gas supplied to the regulator must be between 11" and 13" water column.

•Locate the pipe stub on the back wall or floor

(see “Product Dimensions and Clearances”). Use 5-foot maximum length, 5/8" O.D. flexible gas supply line (3-foot in Massachusetts).

•Install a manual shut-off valve in the gas line

(not provided), in an easily accessible location. Make sure the homeowner knows where and how to shut off the gas supply to the rangetop.

Electric Supply:

These rangetops must be supplied with 120 volt, 60 Hz., and connected to a dedicated, properly grounded branch circuit protected by a 15 amp circuit breaker or time delay fuse.

The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong grounding wall receptacle to minimize the possibility of shock hazard from this appliance.

If the electrical service provided does not meet the above specifications, it is recommended that a licensed electrician install an approved outlet.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT

OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD.

DO NOT USE AN EXTENSION

CORD WITH THIS APPLIANCE.

• Locate the electric supply

within the area shown or within reach of the rangetop’s four-foot power cord.

•To avoid tangling cord with items stored in the cabinet, locate the receptacle on rear wall, inside the cabinet.

7